PC 1252, 12 Volt 52 Amp Batteries In 1300 Peli flight case and a new automatic LED (leads colour coded yellow)
PC 2426, 24 Volt 26 Amp Batteries In 1300 Peli flight case and a new automatic LED (leads colour coded orange
New Large automatic LED is fitted:
2 X 12 Volt 26 Amp Batteries In Peli CASE with 1 x 4-pin XLR output, 1 x fuse & 1 x L.E.D, or can be 3-pin XLR
*** Please add £25 for each extra output
*** Add £15 for pos(+) & neg(-) fuses
*** Add £20 if you would like the battery to switch on when you plug in the output lead, this would use pin 3 of the 4 pin XLR
The Peli Cases comes in black, sand, green, silver, yellow or orange
24 VOLTS battery box output with 4 pin XLR connectors is
on PIN 1 NEG (-), PIN 2 POS (+)
12 VOLTS battery box output with 4 pin XLR connectors is on PIN 1 NEG (-), PIN 4 POS (+)
24 VOLTS battery box output can be fitted with a 2 pin
SPEAKON connectors PIN - 1 NEG (-), PIN + 1 POS (+) a 2 pin
Speakon is preferred because you cannot plug 4 pin Speakon
plug into it. The 4 pin is fitted to the 12 volt battery box
12 VOLTS battery box output is on a 4 pin SPEAKON connectors is on PIN -1 NEG (-), PIN + 1 POS (+)
The 4 pin NC4FX is a 9 amp connector so the box max fuse is 9 amp. NOTE: If you would like a 20 amp output I can fit the SPEAKON connector
The Peli Case Battery is 270 x 246 x 174 mm and is 13.82 Kg
OUTPUT LEADS a 4 pin XLR is used to avoid accidental
connection to audio inputs or microphones
Above leads with 1 x NC4MRX 4-pin XLR Right Angle plug add £3.50
4 pin to clips for charging your car battery £20
It is recommended that a stabilised constant voltage charger
be used with current limiting to restrict the current flow to
the permitted maximum. See Ref: C1, C2 and C3
for suitable chargers.
Car battery type chargers must never be used. These batteries should never be left in a severely discharged condition or get hot when charging.
Charge every 6 months when not in use
The sealed lead acid batteries have proved to be a reliable and economic alternative to nickel cadmium, nickel metal hydride which need to be discharged before recharging if part used and have expensive charging systems plus the memory problems, or expensive Lithium batteries.
The sealed lead acid batteries with the correct charger has no such problems. If the battery is part used it will take less time to charge and for best results, when the battery is fully charged and ready for use, it can be left on float charge until required. So if you forget to take it off charge at the weekend no problem it will just improve the performance by balancing the cells.
Click here for Transportation documents