CLICK ON USED GEAR TO GO BACK
NAGRA ATN 3 POWER SUPPLY AND CHARGER
THIS ATN 3 IS IN AS NEW CONDITION AND IN PERFECT WORKING ORDER, No original rubber end covers, but no plot lead.
AS NEW MAINS POWER SUPPLY FOR NAGRA MONO, STEREO OR TIME CODE RECORDER,
NAGRA MODEL : - IV.L, 4L , 4.2, E, D, IV.S / 4S, 4S T/C, CAN NOT BE USED ON A NAGRA 111
THE ATN 2 NAGRA POWER SUPPLY WILL WORK IN ALL COUNTRIES AND I WILL SUPPLY THE CORRECT MAINS LEAD FOR YOUR COUNTRY
THIS POWER SUPPLY
WORKS FROM 110 TO 250 VOLT AC 50Hz OR 60Hz MAINS SUPPLY, WITH A -35 VOLTS DC
OUTPUT WITH A 6 PIN TUCHEL PLUG TO FIT THE NAGRA
This mains power supply has a built in charger with on/off switch and will charge a 4 amp batteries at 400 ma or 2.5 amp batteries at 250 ma,
I have clean and serviced this unit after these pictures where take but I don't have the rubber edging that should be glued around front and back edging, and I don't have the pilot lead.
PLEASE NOTE: -ALL NAGRAS ARE (+) POSITIVE CASE /SCREEN ON THE DC SIDE
WITH ALL NAGRA'S IT IS NOT A PROBLEM WHEN CONNECTING SCREENED AUDIO SIGNALS BETWEEN THE NAGRA (+ POSITIVE CASE/SCREEN) AND NEW EQUIPMENT (- NEGATIVE CASE/SCREEN). YOU CAN CONNECT THE AUDIO INPUT & OUTPUT CASE/SCREEN TOGETHER, BUT BOTH UNITS MUST BE POWERED FROM THEIR OWN BATTERIES OR OWN POWER SUPPLY.
IF YOU ARE CONNECTING YOUR NAGRA TO VALVE EQUIPMENT YOU WILL NEED TO USE THE ATN TRANSFORMER TYPE POWER SUPPLY, AS THE SMPS THAT IS LISTED ON THIS WEBSITE COULD NOT WORK.
To buy this item please telephone:
MIKE HARRIS 01932 241948 and quote the reference number. For overseas callers
please dial +44 1932 241948