MONO ANALOGUE REEL TO REEL TAPE RECORDER S/N L16106
THIS NAGRA IS IN VERY GOOD CONDITION AND PERFECT WORKING
IT HAS BEEN SERVICED BY ``MIKE HARRIS SOUND SERVICES``AND HAS A 3 MONTH GUARANTEE
Extras, mods and updates with this
Supplied with, a copy of Instruction manual, mono to stereo headphone adapter plug, pilot link plug, shoulder strap fixing screw, a new take up spool a new roll of SM911 STD play tape with test frequency and music for you to test the recorder, this roll of new tape was used to line up the record Bias and EQ, A N-SMPS2 power supply is also included, this power supply can be part exchanged with a Nagra ATN type when you purchase this recorder. And if I have any used leads I will add them to the box.
The machine has the following features:
2 Switchable microphone inputs, for Dynamic, ribbon, T powered and 48p Phantom powered microphones a line input on banana plugs and also on a 6 pin Tuchel ASS socket. It has Direct or off Tape monitoring and metering, monitoring selector with monitor speaker and level control, manual or automatic headphone monitoring with level control. It has 1 & 2 high pass and 1&2 LFA low frequency attenuation filters, 3 tape speeds- 38, 19, 9.5cm/s (15-7.5-3.75ips). 50Hz strobe roller, 1Khtz. Reference generator set at -8dB, automatic recording Limiter, automatic and manual recording level, low frequency attenuation. Metering of most functions. Full set of Ruby tape guides, Mew metal head covers, silicon rubber pinch wheel and drive belts, runs 5" spools and it will run 7" tape spools with the lid open, the lid has lift off hinges, and the case has the fixings for a QGB 10 inch spool adapter and 7 inch spool Perspex lid. And will take a QSV2 speed control in the 6 pin ACC socket
This is a full track mono CCIR recorder, S/N L16106 These recorders can take recording levels of + 6 dB before distortion
This is a full pilot sync record with all circuit boards but if you would like to switch it off just remove the pilot link from the pilot socket on the right hand side of the recorder, if you are not sinking the tape to video or film camera you can leave the pilot link unplugged. BELOW RIGHT, See pilot link plug socket, a pilot sync plug is supplied with this recorder. Above the pilot link and handle fixing screw are the two large case opening screws, please note; only unscrew 3 or 4 turn do not take screws right out, or parts could be lost in the recorder.
ABOVE LEFT, 1 & 2 are 3 pin XLR microphone inputs that are switchable to use Dynamic 48 or 12 volt phantom and "T" powered microphone, The switch for one input is above the VOL control for the speaker output, the ACC 6 pin Tuchel has a Line input and takes the speed control. The line input & output are on the MIXER socket using a 7 pin Tuchel plug or the LINE input is on 4 mm banana plugs. Use the 7 pin MIXER socket that has a Playback or Direct output, leads can be made to order.
ABOVE RIGHT, you have the playback speaker and the PILOT IN socket, for Pilot sync, plug the pilot link plug in this socket, the 4 mm banana sockets are 4.4 volts output at 600 ohm,
POWER PACK, 6 pin Tuchel socket, you can use the 24 volts ATN power supply, the 35 volts ATN 2 or ATN 3 power supplies, an ATN 3 with battery charger or the UAP11 or 12 power supply on main page.
The 35 volt will give a much faster rewind speed. But must not be used on a Nagra III. The Nagra runs on an internal -10 volt regulated power supply, so you can run the batteries down to almost 10 volt before changing the batteries. Please use leak-proof batteries.
ABOVE: The heads are in good condition and no head loss adjustment was needed when lining up the biasing, the tape bias and EQ.
The tape I supply on this Website as been selected because the gain and HF is close to the old AGFA 468 or 368, Zonal 468 / 368 and BASF 468 or 368, ABOVE LEFT: The speed and EQ switch has two positions for each speed, 1 can set STD to flat and LN can de set to a HF roll off or lift, whatever you prefer. Or I have found that the SM911 standard play tape, can be setup for Speed & Equalization STD and the SM368 and the LPR35 long play tape is the same bias and can be use on speed & equalization LN.
This recorder has lift off hinges and there is no major damage to them the case is in good condition.
The recorder works from 12 x U2 batteries or external ATN mains supply or a SMPS power supply see item UAP6 to 12 (not included)
ON THE RIGHT, A full recorder, the second microphone input switching is behind the meter with a black knob, it has all the pilot boards are fitted, The auto record level board is also fitted. And the Crystal Pilot Generator. But a QSV2 speed control will still work if it's a pilot sync recorder or not, when plugged into the ACC socket (QSV2 not supplied)
The battery box is clean and connectors are in good order but there has been a little battery corrosion on the right hand side of the recorder as you can see below
Nagra is the best reel-to-reel tape recorder ever made with
the best of Swiss engineering that you are never likely to see again.
One of the joys of owning a Nagra is that it is an all in one over the shoulder recorder and when you switch it on you know it's going to work and give you a professional quality recording in any conditions
To buy this item please contact: Mike Harris on Email ; firstname.lastname@example.org