Item UMN4

NAGRA I-S MONO CCIR FULL TRACK ANALOGUE REEL TO REEL TAPE RECORDER

THIS NAGRA IS IN VERY GOOD CONDITION AND PERFECT WORKING ORDER.
IT HAS BEEN SERVICED BY ``MIKE HARRIS SOUND SERVICES``
AND HAS A 3 MONTH GUARANTEE

To buy this item please email : Mike Harris on mike.sound@btinternet.com

This Nagra IS-L SPEC No 03 s/n 0702101

Recorder is smaller than a Nagra 4.2 and a masterpiece of engineering that runs on 3 stepper motors

This recorder has a battery box and comes with test tape and take up spool, and copy of instruction manual.

This recorder has push button fast foreword and rewind, push ones to start, push again to stop, a playback button and press the red and line buttons together to record, all driven by 3 stepper motors. Even the lid cache is a work of art

The Perspex lid is new and the catch is working fine, The strobe roller in front of the record head has a LED below when paying in sync and you see a wagon wheel affect

A nice cleaned undamaged Tape Recorder in perfect working order.

ABOVE LEFT and below right this one is with A.L.C, Automatic level control or meter level, and you can read the battery level when you push the rewind button when in play or record.

ABOVE RIGHT, L.F.A FILTER switch( low frequency attenuator) and TAPE DIRECT switch, 2 control is the microphone 2 line & playback control, when you have the 4 mm input sockets.

ABOVE LEFT, the REF .GEN, put a -8 dB tone in the tape when in record, when the slider under the buttons is pushed to the right, it stops the record button being pushed accidentally when playing tapes.

On the top deck this recorder as 1 speed fitted and is set to 7.5 ips, The BRAKES switch is use when splicing to tape.

ABOVE LEFT, 2 Handle fixing screw sockets, then the Headphone socket that will take a mono or stereo headphones and the pilot sync plug and socket, the 2 x 4 mm line in banana plugs and the 7 pin Tuchel socket that has line in, pilot and speed control inputs, the clever thumb lever ,when rotated to the right lowers the battery fixing and the battery box or power supply lifts out. To open this recorder, first open the Perspex lid, unscrew the to larger screws (2-3 terns only), that is under the 2 screw on the lilt bar, hold the headphone socket housing and lift the lift bar.

LEFT ABOVE, the other thumb lever you rotate to the left, and on the back of the 2 x XLR Microphone inputs is the XLR lock release lever

ABOVE LEFT, The battery box is in perfect working order. But as we don't ship batteries the batteries are not supplied. This battery box is included with the recorder. On the right you can see the battery contacts and the lever that holds the battery box in place, This recorder will take a ATI or IACC units see power supply's

Above a sprung pin on the right hand hinge will slide out with you finger nail to remove the Perspex lid, this recorder has 3 types on power units that are available to clips on to the recorder, If you don't use the above unit, you can use a Battery box that uses 8 x D type or MN1400 batteries, or IACC Rechargeable battery unit, or a Nagra mains power unit, only one of these battery boxes can be supplied if you take the rechargeable IACC unit.

ABOVE RIGHT, Record, Pilot & playback heads are as new, as is the pinch roller.

ABOVE RIGHT, switches for 50 or 60 Hz pilot and switches for type of meter you prefer from, modulo meter, super VU-meter or peak VU-meter

ABOVE LEFT, is the microphone input switching, this recorder has Dynamic, 48 volt phantom and T powered Capacitor microphone inputs

ABOVE, Information on the push button controls and switches that's on top plate of recorder

To buy this item please Email, mike.sound@btinternet.com